Crushed tomatoes (with no added liquid)

1 Recipe

Ingredients

Quantity Ingredient
2,001 - 4,000 ft: 7 min.
4,001 - 6,000 ft: 8 min.
6,001 - 8,000 ft: 9 min.
2,001 - 4,000 ft: 12 min.
4,001 - 6,000 ft: 13 min.
6,001 - 8,000 ft: 14 min.
5 lb.
Above 1,000 ft:
Above 1,000 ft: 15 lb. NOTE: This
Above 1,000 ft: Not recommended.
1,001 - 3,000 ft: 40 min.
3,001 - 6,000 ft: 45 min.
Above 6,000 ft: 50 min.
1,001 - 3,000 ft: 50 min.
3,001 - 6,000 ft: 55 min.
Above 6,000 ft: 60 min.

Directions

A high-quality product, ideally suited for use in soups, stews, and casseroles. This recipe is similar to that formerly referred to as "Quartered Tomatoes."

Quantity: An average of 22 pounds is needed per canner load of 7 quarts; an average of 14 fresh pounds is needed per canner load of 9 pints. A bushel weighs 53 pounds and yields 17 to 20 quarts of crushed tomatoes--an average of 2-¾ pounds per quart.

Procedure: Wash tomatoes and dip in boiling water for 30 to 60 seconds or until skins split. Then dip in cold water slip off skins, and remove cores. Trim off any bruised or discolored portions and quarter. Heat one-sixth of the quarters quickly in a large pot, crushing them with a wooden mallet or spoon as they are added to the pot. This will exude juice. Continue heating the tomatoes, stirring to prevent burning. Once the tomatoes are boiling, gradually add remaining quartered tomatoes, stirring constantly These remaining tomatoes do not need to be crushed. They will soften with heating and stirring. Continue until all tomatoes are added. Then boil gently 5 minutes. Add bottled lemon juice or citric acid to jars (See acidification directions). Add 1 teaspoon of salt per quart to the jars, if desired. Fill jars immediately with hot tomatoes, leaving ½-inch headspace. Adjust lids and process. Recommended process times are given in Table 1, Table 2, and Table 3.

Table 1. Recommended process time for Crushed Tomatoes in a dial-gauge pressure canner.

Style of Pack: Hot. Jar Size: Pints. Process Time: 20 min. Canner Gauge Pressure (PSI) at Altitudes of 0 - 2,000 ft: 6 min.

Style of Pack: Hot. Jar Size: Quarts. Process Time: 15 min. Canner Gauge Pressure (PSI) at Altitudes of 0 - 2,000 ft: 11 min.

Table 2. Recommended process time for Crushed Tomatoes in a weighted-gauge pressure canner. Style of Pack: Hot. Jar Size: Pints. Process Time: 20 min. Canner Gauge Pressure (PSI) at Altitudes 0 - 1,000 ft: 10 lb.

Style of Pack: Hot. Jar Size: Quarts. Process Time: 15 min. Canner Gauge Pressure (PSI) at Altitudes 0 - 1,000 ft: 10 lb.

section of the guide appears to contain some sort of error in the information given within Table 3 above. In the USDA book, there are only TWO sizes of jars specified in the table, but there are THREE separate lines of figures in the table, and it is not completely clear which jar size the second and third entries refer to. I have given the second entry's numbers as those to be used for Quart jars, and below I have reprinted the third entry on the table, for an unknown jar size.

Style of Pack: Hot. Jar Size: ??. Process Time: 10 min. Canner Gauge Pressure (PSI) at Altitudes 0 - 1,000 ft: 15 lb.

Table 3. Recommended process time for Crushed Tomatoes in a boiling-water canner.

Style of Pack: Hot. Jar Size: Pints. Process Time at Altitudes of 0 - 1,000 ft: 35 min.

Style of Pack: Hot. Jar Size: Quarts. Process Time at Altitudes of 0 ~ 1,000 ft: 45 min.

======================================================= === * USDA Agriculture Information Bulletin No. 539 (rev. 1994) * Meal-Master format courtesy of Karen Mintzias

Related recipes